I am sure that they use same pinouts as stock PAS, however,I am trying to install phono wiring on the PC-6
and the PAS 3x manual does not identify which wires on the PC6 are for what.
So, i have 2 2 conductor wire coming for the selector switch, I am almost sure that they get soldered into
eyelet ...
Search found 3 matches
- Mon Jun 03, 2024 8:12 pm
- Forum: Z-Regulated Power Supply, solid state (does not use the 12X4 rectifier tube)
- Topic: clone PC-6 pin outs for phono
- Replies: 2
- Views: 71429
- Mon Jun 03, 2024 4:12 pm
- Forum: Z-Regulated Power Supply, solid state (does not use the 12X4 rectifier tube)
- Topic: clone PC-6 pin outs for phono
- Replies: 2
- Views: 71429
clone PC-6 pin outs for phono
i have tried to read schematic to discover what pin outs are used
for phono input from rca jacks and where i wire the phono rca cable input on this
board.
12, 13 phono in
5,6 phono in
2,3 8,9 selector switch wire input.
Thanks, Charles
for phono input from rca jacks and where i wire the phono rca cable input on this
board.
12, 13 phono in
5,6 phono in
2,3 8,9 selector switch wire input.
Thanks, Charles
- Sun Feb 25, 2024 9:46 pm
- Forum: General tech questions and discussions
- Topic: No signal throughput
- Replies: 1
- Views: 68269
No signal throughput
Recently upgraded three pre amps,
1) selector switch- works wonderfull.
2) Z-psu,PC6,Z pc5- selector switch volume and balance control.
I get no output, tubes lite and they have 24 volts to them, but no output.
3)Pas3 Aikido line preamp, PH20 MM phono, PAS3 regulated power supply, selector switch ...
1) selector switch- works wonderfull.
2) Z-psu,PC6,Z pc5- selector switch volume and balance control.
I get no output, tubes lite and they have 24 volts to them, but no output.
3)Pas3 Aikido line preamp, PH20 MM phono, PAS3 regulated power supply, selector switch ...